List of bearings used in the hubs we sell

We'll try to keep this page updated. Bearings can be found in the hub spares category. The Hope steel bearings fit most hubs, and some are available in stainless steel. We generally try to stock most original bearings too (eg from American Classic or Industry Nine) but these normally work out more expensive and are not necessarily better. The Hope bearings are pretty good quality and if installed and looked after correctly will generally last quite a while in any hub.

DT Swiss

190 hubs

Front centerlock - 6802 both sides
Rear centerlock - non dive side 6802, drive side 6902
Front radial hubs - 6803 both sides
Rear non-disk - non-drive side 6802, drive side 6902
All freehubs - 6902 x 2

240s hubs

Front QR 6-bolt  + centerlock - 6902
Rear QR 6-bolt  + centerlock - 6902
Front Oversized
- 6805
Rear singlespeed
- 6902
All Freehubs
- 6902 x 2

Stan's NoTubes ZTR hubs

Standard ZTR 3.30 and 3.30 Ti hubs (and older "xc" hubs)

Front - 6902
Rear - 6802
Rear Singlespeed - 6802
All freehubs
- 6902 x 2

HD hubs

Front - 6804
Rear - left 6002 / right 6902
Freehub - 6902

Hope Technology

Pro 2 / Pro 2 EVO front hubs

Front - 6804 x 2

Pro 2 EVO (17mm outer diameter rear axle)

Rear main bearings - 6903 x 2
Freehub -
6803 x 2, "17x28mm" x 1

Old Pro 2 (15mm outer diameter axle)

Front - 6804 x 2
Rear main bearings
- 6903 x 2
Freehub
- inner 6802 x 2, outer 6902 x 1

Pro 2 Evo (and old pro 2) Singlespeed

rear main bearings - 6903 x 2
freehub - roller bearing x 1, 6902 x 1